You are advised to spend 20 minutes on Questions 1-14. First, read the text below and answer Questions 1-8.

Your Moulex Iron

GT reading your moulex iron 1

Filling the reservoir
Your iron is designed to function using tap water. However, it will last longer if you use distilled water.
— Always unplug the iron before filling the reservoir.
— Always empty the reservoir after use.

Temperature and steam control
Your Moulex iron has two buttons which control the intensity of heat produced by the iron. You can, therefore , adjust the temperature of the iron and the amount of steam being given off depending upon the type of fabric being ironed.

— Turn the steam control to the desired intensity.
— Turn the thermostat control to the desired temperature.
Important: If your iron produces droplets of water instead of giving off steam, your temperature control is set too low.

C  Spray button
This button activates a jet of cold water which allows you to iron out any unintentional creases. Press the button for one second.

Pressing button
This button activates a super shot of steam which momentarily gives you an additional 40g of steam when needed.
Important: Do not use this more than five successive times.

E  Suits etc.
It is possible to use this iron in a vertical position so that you can remove creases from clothes on coathangers or from curtains. Turning the thermostat control and the steam button to maximum, hold the iron in a vertical position close to the fabric but without touching it. Hold down the pressing button for a maximum of one second. The steam produced is not always visible but is still able to remove creases.

Important: Hold the iron at a sufficient distance from silk and wool to avoid all risk of scorching Do not attempt to remove creases from an item of clothing that is being worn, always use a coathanger.

F  Auto-clean
In order that your iron does not become furred up, Moulex have integrated an auto-clean system and we advise you to use it very regularly (1-2 times per month).

— Turn the steam control to the off position.
— Fill the reservoir and turn the thermostat control to maximum.
— As soon as the indicator light goes out, unplug the iron and, holding it over the sink, turn the steam control to auto-clean. Any calcium deposits will be washed out by the steam. Continue the procedure until the reservoir is empty.

Questions 1-4:
Match the pictures below to the appropriate section in the instructions.

Write the correct letter A-F in boxes 1-4 on your answer sheet.

GT reading your moulex iron 2

Questions 5-8
Answer the following questions on the Moulex iron using NO MORE THAN THREE WORDS. Write your answers in boxes 5-8 on your answer sheet.

5 What sort of water is you advised to use?
6 What factor makes you decide on the quantity of steam to use?
7 What should you do if your iron starts to drip water?
8 What could damage your iron if you do not clean it?

1.D   2.A   3.C   4.E   5.distilled (water)  6.the (type of) fabric   7.turn up/ increase temperature  8. calcium deposits/  furring up

دیدگاهتان را بنویسید

WhatsApp Call